SPECIFICATIONS 5 PARADIGM Panel System USA – FEBRUARY 2025 PANELS AND COMPONENTS (cont’d) Stackable panels Panel dimensional range • Stackable panels can be used to increase panel height if necessary during a reconfiguration. • A stackable panel can be installed over a monolithic* or segmented panel. • A stackable panel cannot be installed over a glass segmented panel. • Total panel height, including stackable panels, cannot exceed 667/ 8" (1700 mm). • A maximum of 2 stackable panels can be used. Their combined height cannot exceed the height of the base panel. • A glass stackable panel cannot accept any other stackable component. • A stackable panel cannot support any storage unit or accessory. 48" (1219 mm) monolithic panels can accept stackable panels. However, the height of the end-of-run trim and the junction kits must be cut at the installation job site. * • Segmented panels are factory-assembled. • Different finishes can be applied on each side of a panel. Refer to the codification table (see page 17). • A segmented panel can have only one glass segment, always positioned on the upper portion. • The glass segment cannot support a storage unit or an accessory. 667⁄ 8" H (1700 mm) 545⁄ 8" H (1386 mm) 483⁄ 8" H (1229 mm) 421⁄ 4" H (1072 mm) 297⁄ 8" H (758 mm) Upper segment 123/ 8" (314 mm) or 243/ 4" (628 mm) Middle segment 123/ 8" (314 mm) Base Some combinations are not available as a standard order. Contact the Special Orders department at special@groupelacasse.com. Available finishes: Fabric, laminate or combined Available finishes: Fabric, laminate, glass or combined Available finishes: Fabric or laminate Available finishes: Fabric, laminate or glass Monolithic panel Segmented panels
RkJQdWJsaXNoZXIy ODQzOTcy